0.9N/m, 20kHz, Symmetric Tip, No Coatings, 10-Pack

  • A pack of 10 High quality etched silicon probes for contact mode imaging in air.

    Unmounted for use on standard AFM's.

    Bruker's flagship RESP probes are the preferred choice for high-sensitivity silicon probe imaging in contact mode in air. Every aspect of the RESP design has been optimized to provide the most accurate profiling of microscopic features. With precisely controlled cantilever geometry to enable repeatable scanning parameters, an extra sharp tip radius to reduce the AFM's minimum detectable feature size, and a taller tip to minimize squeeze film damping, the RESP is the industry standard for high-performance and high-quality imaging on a wide variety of sample types.

    The new design provides:

    • Tighter dimensional specifications for improved probe to probe consistency
    • Tighter alignment of the tip apex to the cantilever resulting in easier laser positioning over the tip
    • Improved probe quality and aesthetics

    This AFM probe is unmounted for use on any AFM and is also available with Aluminum reflex coating as model RESPA-20

  • This probe uses a rotated tip to provide a more symmetric representation of features over 200nm.

    Tip Geometry: Rotated (Symmetric)
    Tip Height: 10 - 15
    Front Angle: 15 ± 2
    Back Angle: 25 ± 2
    Side Angle: 17.5 ± 2
    Tip Radius (Nom): 8
    Tip Radius (Max): 12
    Tip Set Back (Nom): 9.5
    Tip Set Back( RNG): 7 - 12

  • Cantilever Material: 0.01 - 0.025 Ωcm Antimony (n) doped Si
    Cantilever Thickness (Nom): 3.25
    Cantilever Thickness (RNG): 2.5 - 4.0
    Cantilever Geometry: Rectangular
    Cantilevers Number: 1